CRM Mitchell1

Home / Archives for CRM Mitchell1 / Page 3

We Service and Repair all CRM Mitchell1 cars

  • 2022 Chevrolet Silverado 2500 HD

    Chevrolet Silverado 2500 HD
    Mileage
    47,591
    Service Date
    11/3/2025
    Services Performed
    • Remove wheels, inspect pad/shoe condition & thickness Front _85__% Rear _90__% Inspect caliper/cylinder for leakage & operation Inspect master cylinder, brake lines & hoses for operation & leaks
    • True rotors or drums, pack bearings & replace seals (if applies), bleed & adjust.Test drive for proper operation.
     
    PAUL N. gave our service a 5 star review on 11/4/2025
  • 2021 Nissan Rogue

    Nissan Rogue
    Mileage
    77,704
    Service Date
    10/17/2025
    Services Performed
    • Used Scan Tool on Vehicle Trouble Codes Found: #P014C air fuel ratio sensor rich to lean performance #P015A air fuel ratio sensor delayed response #P015B air fuel ratio sensor switching delayed Scan system data – bank 1 sensor 1 oxygen sensor slow to range Check sensor and connections Test sensor – high resistance Need to replace bank 1 sensor 1 and recheck Remove old oxygen sensor and clean pipe threads Install new oxygen sensor and torque to spec Reassemble and clear codes Test drive for proper operation Running good and no codes returning at this time
    • Remove air intake tube Add chemicals to vehicle injection adamizer Pressurize adamizer and start cleaning procedure Clean for 20 minutes Remove injection adamizer Reassemble air intake tube Test drive for proper operation
     
    CHRISTINE F. gave our service a 5 star review on 11/3/2025
  • 2018 Honda CR-V

    Honda CR-V
    Mileage
    50,930
    Service Date
    10/29/2025
    Services Performed
    • Remove nail and plug right rear tire Adjust all tire pressures
     
    PAM R. gave our service a 5 star review on 10/29/2025
  • 2012 Chevrolet Silverado

    Chevrolet Silverado
    Mileage
    112,164
    Service Date
    10/28/2025
    Services Performed
    • Raise vehicle on hoist to inspect Test battery and charging system – Charging 14.1 volts Battery failed load test Check cooling system – No coolant in system and misfire in #1 cylinder Perform combustion gas test – failed test Need to remove cylinder heads and inspect for blown head gasket Check belts and hoses – Belts and hoses cracking Check for tune up – Spark plugs worn Check wheels and tires – 11/32 Check brakes: Front _50__ % Rear__70_ % Check steering and suspension Check shocks and struts Check fluids Check for fluid leaks Check axle shafts and boots Check lights and turnsignals Check AC operation. Blowing _50_* at this time
    • Remove cylinder head and inspect Check cylinder head for warp and cracks Check cylinders for damage Reassemble cylinder head Reinstall, torque and adjust Adjust valves if needed Change oil and filter Check belts and hoses Refill fluids Flush cooling system Pressure test cooling system Test drive for proper operation
    • Change oil,filter & lube. Check all fluids, hoses & belts. Check tires & adjust pressure.
    • Drain cooling system Remove serpentine belts Remove old water pump and clean gasket surfaces Install new O-rings and gasket Install new thermostat Install new water pump and torque bolts Reassemble and install new belts Flush and refill cooling system Pressure test for leaks Test drive for proper operation
    • Replace battery, clean cables and posts Check and fill fluid Test battery and charging
    • Lead Acid Battery Fee
     
    BOB D. gave our service a 5 star review on 10/29/2025
  • 2006 Toyota Sienna

    Toyota Sienna
    Mileage
    218,113
    Service Date
    10/24/2025
    Services Performed
    • Change oil,filter & lube. Check all fluids, hoses & belts. Check tires & adjust pressure.
     
    DANE H. gave our service a 5 star review on 10/24/2025
  • 2015 Jeep Cherokee

    Jeep Cherokee
    Mileage
    96,669
    Service Date
    10/17/2025
    Services Performed
    • Used Scan Tool on Vehicle Trouble Codes Found: #P0456 evap system very small leak Check gas cap Check for vacuum and vapor leaks Check electrical connections Smoke test for leaks Found plastic evap leak detection pump leaking at O-ring Need to replace leak detention pump and recheck
    • Used Scan Tool on Vehicle Trouble Codes Found: #U002 can c bus off performance Check for Tech Bulletins Check battery and connection Check computer Remove wire harness connector and clean Reassemble and clear code Test drive – No other problems at this time
    • Remove old evap system leak detection pump and install new pump Reassemble and clear code Test drive for proper operation Running good and no codes returning at this time
     
    RICHARD B. gave our service a 5 star review on 10/18/2025
  • 2008 Toyota Tacoma

    Toyota Tacoma
    Mileage
    148,728
    Service Date
    10/1/2025
    Services Performed
    • Test battery – testing weak Check and found bad connection at positive cable end Remove old battery and clean cables Install new positive battery cable end Install new battery and reassemble Starting good and charging 14.1 volts
    • Lead Acid Battery fee
    • Tune up: Adjust valves (if needed),adjust timing, idle, EFI (or carburetor) & scope. Change oil,filter & lube Check all fluids, hoses & belts Service battery and cables Service transmission & differential Flush cooling system & refill Replace cabin air filter Rotate tires & adjust pressure Check brakes Front__30_% Rear_60__% Test drive for proper operation
     
    JIM B. gave our service a 5 star review on 10/1/2025
  • 2014 GMC Acadia

    GMC Acadia
    Mileage
    125,949
    Service Date
    9/30/2025
    Services Performed
    • Used Scan Tool on Vehicle Trouble Codes Found: #B0021 passenger seat side air bag deployment loop resistance above normal Scan system data – resistance high Check electrical connections Remove passengers seat and test connector Clean, tighten and lube passengers side air bag connector Reconnect and retest resistance – test with in spec Clear code and test drive for proper operation No codes returning at this time Need to check at GMC Dealer if returns again
     
    DAVE H. gave our service a 5 star review on 9/30/2025
  • 2016 Chevrolet Equinox

    Chevrolet Equinox
    Mileage
    133,703
    Service Date
    9/22/2025
    Services Performed
    • Used Scan Tool on Vehicle Trouble Codes Found: #P0010 intake camshaft position actuator solenoid valve circuit #P0011 intake camshaft position system performance Scan system data – both intake and exhaust actuators slow to operate Check actuators and connections Test actuators slow to move Recommend replacing both intake and exhaust actuators and recheck Remove old intake and exhaust actuators and clean oil passages Install new intake and exhaust actuators and reassemble Clear codes and test drive for proper operation Running good and no codes returning at this time
    • Remove air intake tube Add chemicals to vehicle injection adamizer Pressurize adamizer and start cleaning procedure Clean for 20 minutes Remove injection adamizer Reassemble air intake tube Test drive for proper operation
    • Remove old serpentine belt and tensioner Install new belt and new tensioner Reassemble and test drive for proper operation
    • Change oil,filter & lube. Check all fluids, hoses & belts. Check tires & adjust pressure.
    • Remove old sway bar links and bushings Install new sway bar links and bushings Reassemble and test drive for proper operation
    • Remove all ignition coils Remove old spark plugs Gap and install new spark plugs Reassemble and test drive for proper operation
     
    AMANDA J. gave our service a 5 star review on 9/24/2025
  • 2006 Chevrolet Silverado

    Chevrolet Silverado
    Mileage
    289,618
    Service Date
    9/18/2025
    Services Performed
    • Raise the vehicle on the hoist and inspect Found powersteering fluid leaking from rack & pinion Need to replace rack & pinion and reheck
    • Raise vehicle on hoist Remove both front wheels Disconnect outer tie rod ends from wheel hub Remove outer tie rod ends from old steering rack and pinion Disconnect fluid lines and remove old rack and pinion from vehicle Install new outer tie rod ends on to new rack & pinion Install new steering rack and pinion and reassemble Test drive for proper operation
     
    FRANK Y. gave our service a 5 star review on 9/18/2025