Install system gauges and check system pressures – system empty Add freon and leak test AC system Found both schrader valves leaking Replace both schrader valves and add leak detection dye Evacuate and recharge AC system Test drive for proper operation Blowing 41* at this time
Remove old serpentine belt Install new belt and adjust Test drive for proper operation
MICHAEL A. gave our service a 5 star review on 8/19/2026
Raise vehicle on hoist Inspect skid panel Skid panel falling off Bend and straighten skid panel back onto vehicle Replace missing bolts Test drive for proper operation Skid plate good at this time
TALIA W. gave our service a 5 star review on 8/6/2026
Raise the vehicle on the hoist and remove wheels Inspect brakes Front Rear Flush and bleed brake system until clean Reassemble and test drive for proper operation
Remove air intake tube Add chemicals to vehicle injection adamizer Pressurize adamizer and start cleaning procedure Clean for 20 minutes Remove injection adamizer Reassemble air intake tube Test drive for proper operation
Raise the vehicle on the hoist and remove wheels Inspect brakes Front Rear Flush and bleed brake system until clean Reassemble and test drive for proper operation
Remove air intake tube Add chemicals to vehicle injection adamizer Pressurize adamizer and start cleaning procedure Clean for 20 minutes Remove injection adamizer Reassemble air intake tube Test drive for proper operation
Raise vehicle on hoist to inspect Test battery and charging system – Charging 14.1 volts Check cooling system Check belts and hoses Check for tune up Check wheels and tires Check brakes: Front _80__ % Rear_80__ % Check steering and suspension Check shocks and struts Check fluids Check for fluid leaks Check axle shafts and boots Check lights and turnsignals Check AC operation. Blowing _44_* at this time
Disconnect power steering lines and drain fluid Remove old power steering pump Transfer brackets and fittings to new pump Install customers new powersteering pump and torque bolts Reconnect lines and install customers new belt Refill fluid and bleed system lock to lock Test drive for proper operation No leaks at this time
Replace radiator cap and fill coolant
DARTAGNAN W. gave our service a 5 star review on 4/21/2026
Install system gauges and check system pressures – Pressure normal Leak test AC system – No leaks detected Test drive for proper operation Found blower in-op at times Check power and ground to blower motor 12 volts Tap on motor and starts turning Need to replace blower motor & resister Remove passenger side lower dash panel Disconnect electrical connector from blower motor resistor Remove mounting screws and blower motor resistor from housing Install new blower motor resistor and secure mounting screws Disconnect connector and remove blower motor retaining screws Remove blower motor and install new blower motor assembly Reconnect connectors, reinstall trim panel, and reconnect battery Verify blower operation – running properly
Remove wheels, inspect pad/shoe condition & thickness Front _60__% Rear _50__% Inspect caliper/cylinder for leakage & operation Inspect master cylinder, brake lines & hoses for operation & leaks Found both front and rear brakes squeak Recommend clean, deglaze and apply stop squeak
Clean and deglaze brake pads and rotors Apply stop squeak to brake pads Test drive for proper operation.
Clean and deglaze brake pads and rotors Apply stop squeak to brake pads Test drive for proper operation.
DWAYNE B. gave our service a 5 star review on 3/11/2026
Remove front wheels Remove calipers and rotors Remove outer tie rod end – joint worn Remove strut from knuckle and strut tower Remove both front struts Compress springs and remove old struts Install new struts and reassemble with springs Reassemble and reinstall strut in to vehicle Install new outer tie rod ends Send for alignment Test drive for proper operation
Support engine assembly Remove right front motor mount Install new motor mount and reassemble Test drive vehicle for proper operation
ELIZABETH F. gave our service a 5 star review on 1/30/2026